General Procedures and Functional Checks
4-48 LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
Restore System Presets and Configurations
1. Insert the Backup/Restore DVD-R disk (or USB memory
device, SD Card) into the drive.
2. Go to Utility -> System -> Backup/Restore
NOTE: If you are not logged in with administrator privileges, the
Operator Login window is displayed. Log on with
administrator privileges.
3. In the Restore list, select Patient Archive, Report Archive,
User Defined Configuration and Service.
4. In the Media field, select the Backup/Restore DVD-RW (or
USB memory device, SD Card).
5. Select Restore.
The system performs the restore. As it proceeds, status
information is displayed on the Backup/Restore screen.
After the Restore completes, the system need to reboot.
Figure 4-22. Backup/Restore Menu
CAUTION
The restore procedure overwrites the existing database on the
local hard disk drive. Make sure to insert the correct DVD (or
USB memory device, SD Card).
To Next Page
Loading...
Need help?
General
