Introduction
1-26 LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
Battery Safety
To avoid the risk of injury, follow the warning and cautions to
make sure that the battery does not burst, ignite, or generate
heat of fumes.
WARNING
• The battery has a safety device. Do not disassemble or
alter the battery.
• Charge and discharge the batteries only when the ambient
temperature is between 10° and 40° C (50° F and 104° F).
• Do not short-circuit the battery by directly connecting the
negative terminals with metal objects.
• Do not heat the battery or discard it in a fire.
• Do not expose the battery to temperature over 50° C
(122° F). Keep it away from fire and other heat sources.
• Do not charge the battery near a heat source, such as a
fire or heater.
• Do not leave the battery in direct sunlight.
• Do not drop packs from height to prevent them from
possible malfunction damage.
• Do not drop packs from height to prevent them from
possible malfunction damage.
• Do not pierce the battery with a sharp object, hit it, or step
on it.
• Do not use a damaged battery.
• Do not solder a battery.
• Do not connect the battery to an electrical power outlet.
• Do not contact PCM (Power Control and Monitor, it’s a
small board in the battery) directly to prevent packs from
ESD damage.
• In case of longer non-use of the LOGIQ e, please make
sure the battery is removed.
To Next Page
Loading...
Need help?
General
