GE LOGIQ e - Network Configuration; Contents in this Section

Network Configuration
LOGIQ e – Basic Service Manual 7-17
5461614-100 English Rev. 6
Network Configuration
Contents in This Section
• ‘Network Configuration’ on page 7-17
• ‘Wire-LAN Network’ on page 7-17
• ‘Wireless LAN Network’ on page 7-19
• ‘Software Download’ on page 7-20
Network Configuration
Wire-LAN Network
1. Connect system with network.
2. Enter Utility-> Connectivity-> TCP/IP, in IP settings
window, check Enable DHCP, and select the proper
network speed in Network Speed.
Figure 7-10. Enable DHCP