Maintenance task schedule
LOGIQ e – Basic Service Manual 10-11
5461614-100 English Rev. 6
Maintenance task schedule
How often should maintenance tasks be performed?
The Care and Maintenance task schedule (provided in
Table 10-3 on page 10-11) specifies how often your LOGIQ e
should be serviced and outlines items requiring special
attention.
NOTE: It is the customer’s responsibility to ensure the LOGIQ e care
and maintenance is performed as scheduled in order to retain its
high level of safety, dependability and performance.
Your GE Service Representative has an in-depth knowledge of
your LOGIQ e and can best provide competent, efficient service.
Contact GE for coverage information and/or price for service.
The service procedures and recommended intervals shown in
the Care and Maintenance Task Schedule assumes that you
use your LOGIQ e for an average patient load (10-12 per day)
and not use it as a primary mobile Ultrasound system which is
transported between diagnostic facilities.
NOTE: If conditions exist which exceed typical usage and patient load,
then it is recommended to increase the periodic maintenance
frequencies.
Table 10-3: Customer Care Schedule
Service at Indicated
Time Daily Weekly Monthly
Per
Facilities
QA
Program
Notes
Clean Probes •* * or before each use
Inspect AC Mains Cable • Mobile Ultrasound
system: Check
Weekly
Inspect Cables and
Connectors
•
Clean Console •
Clean LCD •
To Next Page
Loading...
