GE LOGIQ e Basic Service Manual

System Setup
3-18 LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
Connect a probe (continued)
2. Position the probe cable so that it is not resting on the floor.
Figure 3-9. Probe connectors
Disconnect a probe
Follow these steps to disconnect a probe:
1. Remove the connector from the port.
2. Ensure that the probe head is clean before placing the
probe in its storage case.
Probe Latch

GE LOGIQ e Specifications

General

Brand	GE
Model	LOGIQ e
Category	Medical Equipment
Language	English