GE Power Quality Meter Series

9-2 PQM Power Quality Meter GE Power Management
9.1 COMMISSIONING 9 COMMISSIONING
9
S2 SYSTEM SETUP
CURRENT/VOLTS CONFIGURATION
PHASE CT WIRING
PHASE CT PRIMARY A
NEUTRAL CURRENT SENSING
NEUTRAL CT PRIMARY A
VT WIRING
VT RATIO
VT NOMINAL SEC VOLTAGE V
NOMINAL DIRECT INPUT VOLTAGE V
NOMINAL SYSTEM FREQUENCY Hz
ANALOG OUTPUT 1
ANALOG OUTPUT RANGE mA
ANALOG OUT 1 MAIN
MAIN 4 mA VALUE
MAIN 20 mA VALUE
ANALOG OUTPUT 1 ALT
ALT 4 mA VALUE:
ALT 20 mA VALUE
ANALOG OUTPUT 2
ANALOG OUT 2 MAIN
MAIN 4 mA VALUE
MAIN 20 mA VALUE
ANALOG OUTPUT 2 ALT
ALT 4 mA VALUE
ALT 20 mA VALUE
ANALOG OUTPUT 3
ANALOG OUT 3 MAIN
MAIN 4 mA VALUE
MAIN 20 mA VALUE
ANALOG OUTPUT 3 ALT
ALT 4 mA VALUE
ALT 20 mA VALUE
Table 9–1: PQM SETPOINTS (Sheet 3 of 11)
S2 SYSTEM SETUP continued
ANALOG OUTPUT 4
ANALOG OUT 4 MAIN
MAIN 4 mA VALUE
MAIN 20 mA VALUE
ANALOG OUTPUT 4 ALT
ALT 4 mA VALUE
ALT 20 mA VALUE
ANALOG INPUT
ANALOG IN MAIN/ALT SELECT RELAY
ANALOG IN MAIN NAME
ANALOG IN MAIN UNITS
MAIN 4 mA VALUE
MAIN 20 mA VALUE
ANALOG IN MAIN RELAY
ANALOG IN MAIN LEVEL
ANALOG IN MAIN DELAY sec.
ANALOG IN ALT NAME
ANALOG IN ALT UNITS
ALT 4 mA VALUE
ALT 20 mA VALUE
ANALOG IN ALT RELAY
ANALOG IN ALT LEVEL
ANALOG IN ALT DELAY sec.
SWITCH INPUT A
SWITCH A NAME
SWITCH A FUNCTION
SWITCH A ACTIVATION
SWITCH A TIME DELAY sec.
SWITCH INPUT B
SWITCH B NAME
SWITCH B FUNCTION
SWITCH B ACTIVATION
SWITCH B TIME DELAY sec.
Table 9–1: PQM SETPOINTS (Sheet 4 of 11)