om 5184516-100 Rev. 5 B-6
After the “QAP” is started, the system will take several seconds to compute
system electronic noise.
Then, the screen will transition to the Step 1 Instruction Screen with the fol-
lowing instructions:
Step 1 of 3
• Adjust the tower so the the SID is equal to the value displayed in the
screen instructions, +/-5 mm. Lock the tower at that height.
• Place a 12x12x1/32 inch copper sheet on the top of the table in the center
of the field of view. Ensure that the copper sheet attenuates the entire X-
ray field.
• Verify that the compression cone is removed from the cone holder.
• Depress the hand switch and release after at least 2 images have been
acquired. (The number of images acquired is displayed on the image
monitor.)
• Select the “CONTINUE” button when finished.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
