GE Responder 2000

2026116-001 Revision B Responder™ 2000 Page 110
CLEANING RESPONDER 2000 AND ACCESSORIES
It is recommended that the Responder 2000 and its accessories to be inspected after each use according to the
Defibrillator Checklist in this manual and cleaned when appropriate.
Listed below are recommendations for cleaning the Responder 2000 and its accessories.
RECOMMENDED CLEANING PRODUCTS
The following cleaning products may be used to clean the exterior surfaces of the Responder 2000 as well as the
batteries:
• 3% Hydrogen Peroxide
• 100% Ethyl Alcohol
• 91% Isopropyl Alcohol
• Mild soap and water
• Do not use abrasive cleaners or strong solvents such as acetone or acetone-based cleaners.
• Do not mix disinfecting solutions (such as bleach and ammonia) as hazardous gases may occur
• Do not clean electrical contacts or connectors with bleach.
CLEANING INSTRUCTIONS
1. Before cleaning the Responder 2000, turn the device off, disconnect the power cord, and remove battery.
2. Before cleaning, also remove all adherent soil (tissue, fluids, etc.) and wipe thoroughly with a cloth dampened with
water before applying the cleaning solution.
3. When cleaning, do not immerse.
4. Wring any excess moisture from the cloth before cleaning.
5. Avoid pouring fluids on the device, and do not allow fluids to penetrate the exterior surfaces of the device.
6. To prevent scratching the display, the use of a soft cloth is recommended.
PRECAUTION: To prevent damage to equipment, do not clean any part of the Responder 2000 or its accessories (with
the exception of internal paddles/spoons) with phenolic compounds. Do not use abrasive or flammable cleaning agents.
Do not steam, autoclave, or gas-sterilize the Responder 2000 or accessories.
WARNING: Cleaning liquids: DO NOT submerge the device in liquids or pour cleaning liquids over, into or onto the
device.