2026116-001 Revision B Responder™ 2000 Page 31
INSTALLING PAPER INTO THE PRINTER
To install paper into the printer, follow these instructions.
Lift up on the front printer flap as shown by arrow on the Responder 2000. Pull door flap up and forward to open the
printer.
Place paper roll into the printer with the paper end pulled over the top of the printer roller through the opening in the
printer door. Refer to printer door for proper direction of paper.
Close the printer and press the door into place until it clicks. The paper should be protruding from the slot in the printer
housing. The paper may be torn off flush with the front of the Responder 2000 after installation.
PRECAUTION: Printer paper may jam if paper is wet. Printer may be damaged if wet paper is allowed to dry while in
contact with printer elements. Use only printer paper listed in section 7 “Accessories”.
To Next Page
Loading...
Need help?
General
