GE Responder 2000

2026116-001 Revision B Responder™ 2000 Page 128
ESD: IEC 61000-4-2 (2001), Electromagnetic compatibility (EMC) - part 4-2: testing and measurement techniques -
electrostatic discharge immunity test; Level 3. IEC 60601-2-4 (2002), Section 36.202.2.
Conducted: IEC 61000-4-6 (2003), Electromagnetic compatibility (EMC) - part 4-6: testing and measurement techniques -
immunity to conducted disturbances, induced by radio-frequency fields. IEC 60601-2-4 (2002), Section 36.202.6.
Fast transients and bursts: IEC 61000-4-4 (2001), Electromagnetic compatibility (EMC) - part 4: Testing and
measurement techniques - section 4: Electrical fast transient/burst immunity test. IEC 60601-2-4 (2002), Section
36.202.4.
Surges: IEC 61000-4-5 (2001), Electromagnetic compatibility (EMC) - part 4: Testing and measurement techniques -
section 5: Surge immunity test. IEC 60601-2-4 (2002), Section 36.202.5.
Voltage dips, short interruptions and voltage variations on power supply input lines: IEC 60601-4-11 (2004),
Electromagnetic Compatibility (EMC) - Part 4-11: Testing And Measurement Techniques - Voltage Dips, Short
Interruptions And Voltage Variations Immunity Tests.
ENVIRONMENTAL STANDARDS
SHOCK AND VIBRATION
The Responder 2000 is tested per the following when in the unpackaged condition:
Bump: IEC 60068-2-29 (1987), Test EB: bump; 25g, 6 ms, 0.9 m/s ∆V, and 1000 bumps in each direction
Sine Vibration: IEC 60068-2-6 (1995), Environmental testing - part 2. tests - test FC: Vibration (sinusoidal); 0.15mm
displacement amplitude, 10-55Hz, 10 sweep cycles in each axis
Random Vibration: IEC 60068-2-64 (1993), Environmental testing - part 2: test methods - test FH: Vibration broadband
random (digital control) and guidance: 1-100Hz, 0.01g2/Hz 30 minutes.
Free Fall Drop: IEC 60068-2-32 (1975 + A1:1990), Environmental testing - test methods - test ED: free fall; 18 inches
Enclosure Protection: IEC 60529 (2003), Degrees of protection provided by enclosures (IP code); IP22.
STORAGE AND SHIPPING
When packaged in the shipping container, the Responder 2000 meets the requirements of:
ISTA Preshipment Test 2A (2001), Simulation Performance Test Procedure - Packaged-Products 150lb(68 kg) or Less