2026116-001 Revision B Responder™ 2000 Page 112
EXTERNAL COUNTER ELECTRODE FOR INTERNAL DEFIBRILLATION
• Disconnect the electrode from its lead before cleaning or sterilizing it.
• Clean the electrode by rubbing it down with a cloth moistened with soap water. Use a disinfectant for
disinfection. Do not immerse the electrode in the liquid.
• Low-temperature plasma sterilization is the recommended sterilization method. Alternative methods are ETO
sterilization or ionizing radiation. (Please note: Frequent ETO sterilization reduces the life expectancy of the
plastic material!) Do not autoclave the electrodes.
CARING FOR RECHARGEABLE BATTERIES
CALIBRATING THE BATTERY FUEL GAUGE
Time, repeated partial charges and discharges, and battery aging will lead to inaccuracy of the battery fuel gauge. This is
corrected by performing a battery calibration cycle. To maintain useful battery life, it is recommended to calibrate the
rechargeable battery:
• Once every two months
• When the run time of the battery becomes noticeably shorter
• When the predicted run times become noticeably inaccurate
To calibrate a Responder 2000 battery, see Section 2.
RECYCLING THE BATTERIES
When the battery no longer holds a charge, it should be replaced. This condition may occur after 2.5 years or 300
charge/discharge cycles. The batteries are recyclable. Remove the old battery from the Responder 2000 and follow your
local recycling guidelines.
To Next Page
Loading...
Need help?
General
