GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-50 Section 3-7 - Completing the Hardware Installation
8.) Press on the three buttons <CTRL> <ALT> <Page Erase> simultaneously.
The following screen will appear.
Figure 3-48 Intel® Dual Display Clone
9.) Select the Intel® Dual Display Clone icon and press OK - see Figure 3-48
NOTE: If the VGA cable is not properly connected to the rear panel, or in the event that the
scan-converter device is not switched ON, you may see a single icon displayed, as shown in
Figure 3-49.
Figure 3-49 Single Icon
To Next Page
Loading...
