GE Vivid q N - Page 131

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-59
5) Align the connector with the probe port and carefully push into place, as shown in Figure 3-58.
6) Press the connector locking lever upwards to the full vertical position to lock in place, as shown in
Figure 3-59.
7) Carefully position the probe cord so that it is free to move and is not resting on the floor.
When the probe is connected, it is automatically activated.
NOTE: It is not necessary to turn OFF power to connect or disconnect a probe.
Figure 3-58 Connecting Probe to the Vivid q N
Figure 3-59 Securing Probe with Locking Lever
CAUTION
Do not bend the probe cable acutely.
Fault conditions can result in electric shock hazard. Do not touch the surface of probe connectors which
are exposed when the probe is removed. Do not touch the patient when connecting or disconnecting a
probe.