GE Vivid q N - Page 175

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-103
The Local Area Connection Properties dialog box opens.
8.) Select Internet Protocol (TCP/IP).
9.) Click the Properties button.
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid q N IP address 10.0.0.1.
NOTE: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0.
NOTE: The Subnet mask should be the same for both the network computer and the
VividqN.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
NOTE: The following steps are performed on the Network Computer.
1) On the network computer, access the Control Panel, as follows:
Figure 3-106 Local Area Connection Properties
Figure 3-107 Internet Protocol (TCP/IP) Properties