GE Vivid q N - Page 349

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 6 - Service Adjustments 6-5
6-1-2-5-1 Adjusting the Blue Tint
NOTE: The default blue tint test pattern is set at two bars - see Figure 6-7.
1.) Press Alt Q to access the Display Calibration Screen.
2.) To adjust the blue tint: hold down <ALT>, then use the < and > keys, as required.
Repeatedly pressing < will decrease the blue tint; repeatedly pressing > will increase the blue tint.
NOTE: To assist in making blue tint adjustments, an adjustment bar is displayed below the screen -
see Figure 6-8.
3.) Press Alt Q to exit to the Display Calibration Screen.
Figure 6-7 LCD Display Calibration Screen showing Test Pattern
Figure 6-8 Blue Tint Adjustment Bar