GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-52 Section 8-3 - Internal Component Replacement Procedures
5.) Using both hands, lift the Fan Assembly upwards from the front and then the rear to remove it from
the Bottom Assembly; lay it down adjacent to the system, ready for the next step as shown in
Figure 8-61 below.
Figure 8-61 Removing the Fan Assembly
6.) Disconnect the Fan cable from the BEP and completely remove the Fan Assembly from the system,
as shown in Figure 8-62 below.
Figure 8-62 Disconnecting the Fan Cable from the BEP
To Next Page
Loading...
