GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-104 Section 8-5 - Software Loading
6. Proceed with the Software Installation process by
selecting the following option:
Load Installation
then press <Enter>.
Note: In the event that the Service Tools option had
been selected, you would be prompted for a Password.
This would then provide access to the following:
Check System ID - shows current system version etc.
InitNetwork - (for future use only)
Command Prompt - (for future use only)
File loading commences. While in progress, the following screen is displayed:
When complete (after approximately 10 minutes), the following message is
displayed prompting you to select the required option:
7. Select the following option:
Full Clean Install (System + Application +
Documentation)
then press <Enter>.
The following Warning message is displayed:
8. Press [Yes] to continue. The following message is displayed, providing the option to reboot the system
manually (if preferred) when software installation complete:
Table 8-6 Step-by-Step Vivid q N Software Upgrade/Installation/Reinstallation Procedure
Step Instruction Expected Result
NEED REPLACEMENT SCREEN CAPTURE
should show Vivid Q System ID
To Next Page
Loading...
