GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-103
8-5-1-2 Vivid q N Software Upgrade/Installation/Reinstallation Procedure - BT11 to BT12
NOTE: A minimum of 1 hour is required to complete the Software Upgrade/Installation Procedure
(excluding preparation time, backup etc. and performing functional tests following the software
upgrade/installation).
Throughout the installation/upgrade processes, the VividqN system will be unavailable
for scanning.
NOTE: The following upgrade procedure is based on the Vivid i n system. The procedure is the same
for the Vivid q N system (displayed screens will of course reflect Vivid q N information).
NOTE: During the software installation procedure, it is important to observe the USB Flash Drive connected to
the rear panel and make sure the LED is blinking.
Table 8-6 Step-by-Step Vivid q N Software Upgrade/Installation/Reinstallation Procedure
Step Instruction Expected Result
1. Perform a complete shutdown of the system.
2. Remove the battery and remove all peripherals currently
connected to the system.
Make sure no peripherals are connected to the USB
connectors including the DVD and the PCMCIA.
3. Insert the USB Flash Drive containing the full software
version and supporting documentation (P/N 5455533)
into one of the USB ports on the rear panel.
4. On the console, hold down the <ON/OFF> button for
three seconds.
The system powers ON and when system boot-up from the USB Flash Drive is
complete, the following message is displayed prompting you to select the
required option:
5. For a Software Upgrade procedure:
Make sure the Format Hard Disk procedure has been
performed as part of preparation for software loading.
Note:
For a Software Reinstallation procedure, Hard Disk
Formatting is optional.
To Next Page
Loading...
