GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-125
7. Press [Y] to confirm the Hard Disk formatting command. Hard Disk formatting commences.
During this process, a visual indication of progress is displayed on the screen:
When Hard Disk formatting is complete, the system automatically reboots.
The following options are now displayed:
8. Proceed to perform the Software Installation procedure,
as described in:
"Vivid q N Software Upgrade/Installation/Reinstallation
Procedure - BT11 to BT12" on page 8-103.
Table 8-8 Formatting and Partitioning the Hard Disk - Automatic Procedure (cont’d) 2 of 2
Step Instruction Expected Result
To Next Page
Loading...
