80 ADV200 • Quick start up guide
Checks to be performed before powering the drive
• Check that the supply voltage is correct (TN,TT for ADV200 standard series
; IT for ADV200...-IT series) and that the input terminals on the drive (L1, L2
and L3 or C and D for ADV-...-DC) are connected correctly.
• Check that the output terminals on the drive (U, V, and W) are connected to
the motor correctly.
• Check that all the drive control circuit terminals are connected correctly. Check
that all control inputs are open.
Powering the drive
• After completing all the checks described above, power the drive and proceed
to Step 2.
To Next Page
Loading...
