gefran installationSIEIDrive ADL300 User Manual

62 ADL300 • Quick installation guide - Specifications and connection
Connection to a PC with RS232 port (not isolated)
The following are required for connection:
• a shielded cable (code 8S8F59) for connection to the RS232 PC port of the drive to the RS232 connector of the
PC, see gure 7.4.1-B.
Connection to a PC with USB port (not isolated)
The following are required for connection:
• an optional USB/RS232 adapter, code 8S8F62 (including the cable for USB connection)
• a shielded cable (code 8S8F59) for connection to the RS232 PC port of the drive to the USB/RS232 adapter, see
gure 7.4.1-C.
7.5 CAN interface
CANopen is a communication prole for CAL-based industrial systems (refer to the CANopen CAL-Base
COMMUNICATION PROFILE for Industrial Systems; CiA Draft Standard 301 Version 4.2 Date 13 February 2002 by
CAN in Automation e. V.).
The ADL300 can be requested with the interface for connection to CAN networks at the time of ordering
(ADL300-...-C models). The drive also implements the DS417 prole according to CANopen 2.0.0 specications.
The CAN protocol (ISO 11898) used is CAN2.0A with 11-bit identier. The integrated CANopen interface has been
developed as a Minimum Capability Device. Data are exchanged cyclically; the master reads the data made available
by the slaves and writes the reference data to the slaves.
The interface is provided with functional isolation (> 1 kV).
Connection is via the CAN (XC) connector and no power supply is required.
LSHH
CAN connector (XC)
Prg
Enter
BRK n=0ILIMENCNT AL
CAN
CAN LED
Terminal Name Function Cable cross-section
L CAN�L CAN�L bus line (low dominant)
0.2 ... 2.5 mm
2
AWG 26 ... 12
SH CAN�SHLD CAN shielding
H CAN�H CAN�H bus line (high dominant)
LEDs Meaning
CAN (green)
Off Stop
Flashing Pre-operational
On Operational
A shielded twin-pair (of the type described in the CANopen specications) must be used for connection to the bus, and
must be laid separately from the power cables, at a distance of at least 20 cm. Cable shielding must be grounded at
the two ends. If the cable shielding is grounded at different points of the system, use equipotential connection cables to
reduce the current ow between the drive and the CANbus master.
Note! As regards terminations: the first and last termination on the network must have a 120 ohm resistor between pins L and H.
CAN-H
MASTER
CANopen
120 ohm
L
ADL300
SH H
CAN (XC)
120 ohm
L
ADL300
SH H
CAN (XC)
CAN-L
Figure 7.5.1: CANbus connection

gefran installationSIEIDrive ADL300 Specifications

General

Brand	gefran
Model	installationSIEIDrive ADL300
Category	Inverter
Language	English