ENGINE
PROBLEM
POSSIBLE CAUSE
REMEDY
Engine overheats. Crankcase oil level too low or too high.
Add or remove oil as required.
Engine overloaded.
Operate Loader at
112
to full throttle.
Cooling system low on water or coolant.
Add water or coolant.
Fan air circulation blocked or restricted.
With Engine OFF, remove blockage or
restriction.
Fan Shroud improperly positioned.
Contact your Gehl Dealer for assistance.
Grade
of
oil improper or excessively
Drain and replace with clean oil
of
dirty.
proper grade.
Exhaust restricted.
Allow exhaust to cool, then remove the
I'
II
restriction.
Air Filter is restricted.
Replace the Filter.
HYDROSTATIC SYSTEM
PROBLEM
POSSmLE
CAUSE
REMEDY
No response from Hydraulic oil viscosity is too heavy.
Allow longer warm-up or replace
either the Hydrostatic
existing oil with the proper viscosity oil.
Drive or the Lift/Tilt
Systems.
Hydraulic oil supply is to low.
Check for low oil level
in
Reservoir.
Add oil as needed.
Reservoir Strainer is plugged.
Remove Reservoir Cover and clean the
Strainer. Inspect Reservoir for foreign
objects plugging the system.
Traction Drive will not
Parking Brake is engaged.
Disengage Parking Brake.
operate in either
direction.
Hydraulic oil supply is low.
Check for low oil level in Reservoir.
Add oil as needed.
Control Rod Linkage disconnected.
Check Linkage connection at T-Bar and
Neutral Centering Mechanisms.
Reconnect Linkage.
Low or no charge pressure.
Contact your Gehl Dealer for assistance.
Tandem Pump Relief Valves are
Contact your Gehl Dealer for assistance.
malfunctioning.
I
52
To Next Page
Loading...
Need help?
General
