○○○○○○○○○○○○○○○○○○○○○○○
Digital Signal Processor 53
○○○○○○○○○○○○○○○○○○○○○○○
You can also change the general effect volume with the Tempo/Data +/– buttons or
the + and – buttons of the selection keypad.
To change the Rotary effect from Slow to Fast and vice versa, use the ENTER or
ESCAPE buttons.
3. Escape from the current effect function by moving the arrowhead, or by pressing ESCAPE.
The selected effect type(s) are now assigned to the current Performance.
4. Press and hold the STORE PERFORMANCE and confirm with ENTER to save the changes to the current
Performance.
If you select a different Performance, or reselect the same Performance without sav-
ing the changes, the newly assigned effects will be lost and the original settings will
be restored.
DEACTIVATING (BYPASSING) THE EFFECTS
While playing, you can bypass one or both effect types assigned to the current Perform-
ance.
By pressing the REVERB or CHORUS button, you can toggle between the ON and
OFF status.
The corresponding display indicator responds by turning on or off accordingly.
Regulating the Send levels
Each track of the current Performance can be independently adjusted for the amount of
Reverb or Effect applied.
REVSEND
Controls the REVERB level for each track of the current Performance.
CHOSEND
Controls the CHORUS level for each track of the current Performance.
1. Select the Track whose effect level you wish to change.
The corresponding Track indicator starts to flash and the assigned Sound is shown in
the 8 digit display area.
2. Press the PAGE button as many times as necessary until the REVsend or CHOsend page is shown.
The value shown can be modified within the range 00 … 15, and indicates the
amount of effect applied to the track.
II2 33 05 24 49 I09 48 6I 0I
To Next Page
Loading...
Need help?
General
