J-3
Select TEST KEY or EXT KEY from
the SET UP display select cursor to
reload the desired key type.
External Key Load Passed
An External Key has been successfully
loaded into the EMC.
qwdId:
Nothing, informational only
Keyload In Progress
A keyload has been initiated and is on
progress.
qwdId:
Nothing, informational only
J-2.2 SECURENET User Prompt
Warnings
Radio Keyload Complete – Press PTT
Radio keyload has been successfully
done and the use may start the radio test
by pressing the PTT on the radio.
qwdId:
Press PTT to start test.
Select RF Display to Decode B-Band Voice
Baseband Voice Decode is input through
the DVM/IN, VERT/SINAD port on the
front panel when RF Display is selected
as the Metering function. Other
Metering selections use this port for
different inputs and may change the
attenuation on the input signal.
qwdId:
When decoding Baseband Voice select
RF Display as the metering function.
Press KVL PTT to Start Keyload
The EMC is prepared to load an external
key via a KVL key loader. The keyload
is initiated via PTT.
qwdId:
Attach a KVL loader and load an
external key, or press the cancel keyload
softkey.
To Next Page
Loading...
Need help?
General
