General Dynamics R2670 Series - 3-5.1 MONITOR Mode; Figure 3-4. Monitor Mode; Primary Operating Modes

3-5 PRIMARY OPERATING MODES
Select the operating mode by placing the cursor
in the "RF Control:" field in the RF zone. Use
the desired softkey to make selection. Primary
operating modes are:
 MONITOR
 GENERATE
 DUPLEX
 SWEEP GENERATE
3-5.1 MONITOR Mode
The Monitor mode (figure 3-4) provides the
analyzer's test receiver function which is used
in the testing of radio transmitters. It is capable
of monitoring RF input through it's antenna or a
direct connection to the transmitter to accu-
rately determine the frequency, power level,
and modulation characteristics. It monitors
signals from 400 kHz to 999.9999 MHz. Center
frequency is set in 100 Hz increments.
Figure 3-4. Monitor Mode
24