K-3
K-2 WARNINGS
ASTRO W
arnings also fall into two categories
Informational Warnings and User Prompt
Warnings. Informational Warnings provide
feedback to the user, informing the user of results
of actions. User Prompt Warnings prompt the
user to perform some action to continue.
K-2.1 ASTRO Informational Warnings
The following ASTRO Inform
ational Messages
occur as the result of some user or system action.
All of these messages are informational only and
do not require any user action.
External Key Load Passed
An External Key has been successfully
loaded into the EMC.
Keyload In Progress
The operator has selected the load ext key
softkey and then pressed PTT on the KVL.
External Key Erased
The user has erased a previously loaded
External Key.
External Keyload Canceled
The user has chosen to cancel a key load
operation. The system has been restored
from key load mode back to normal
operating mode.
K-2.2 ASTRO User Prompt Warnings
Verify Correct Network ID
When generating ASTRO VOICE, this
message indicates that the user has not
entered a valid Network ID.
qwdId:
In the Audio Zone, cursor down to VOICE
FRAME. Select display table. Change the
Network ID to a nonzero value.
Press KVL PTT to Start Keyload
The user has selected load ext key. The
R2670 is now in key load mode and is
awaiting the start of the key loading
function from the KVL.
qwdId:
Press the KVL PTT to start the key load
or press the cancel softkey to terminate
the key load.
NOTE
Software encryption is different. Either cancel
or set the desired key and then press the
STORE KEY softkey.
Secure Mode Failure
User is attempting to run a secure voice
scenario but is unable to load an
algorithm or key into the Encryption
Module.
qwdId:
Press the encrypt reset softkey.
Warning - Encryption Hardware Failure
One or more algorithms is installed in the
R2670 via the Monitor Service Software
(MSS) but were not detected on either
Encryption Module.
qwdId:
Notify the Service Representative.
To Next Page
Loading...