First try encrypt reset, and if that
fails, notify the Service
Representative.
No Response From Option
The R2670 has attempted to
communicate with the Project 25
Option but has not received a
response.
qwdId:
Verify that the Project 25 Option is
installed. This can be done by
inspecting the Installed Options
window from the Special Functions
(SPF) page.
If the option is installed, press the
encrypt reset softkey from the
system functions line on the SPF
window. This will reset the R2670.
Retry the test. If the message is
redisplayed, perform the nvm clear
from the SPF menu. (This function
will clear all settings previously
input.) Retry the test. If the message
is redisplayed, contact the Service
Representative.
Option Not Responding To Calibration
Msg
A command to start the modulation
calibration for the Project 25 Option
has been generated but the option is
not responding.
qwdId:
Perform an nvm clear from the
Special Functions (SPF) menu to
restart calibration. If the option fails
to respond, notify the Service
Representative.
Astro Option-Failed DSP SRAM Test
Indicates failure of the DSP powerup
test of the three DSP static RAM
chips on the option card.
Astro Option-Failed DSP ROM Test
Indicates failure of the DSP powerup
test of the DSP program ROM on the
option card.
Astro Option-Failed DSP Startup
Indicates failure of the DSP powerup
sequence has been detected by the
HC11 when the required DSP startup
message is not correctly received
from the DSP.
ASTRO Option Timed Out
Indicates failure of the option has
been detected by the 68k during
powerup when the required
diagnostic response has not been
received from the HC11.
qwdId:
For the above four messages, first try
to reset the analyzer. If this fails
notify the Service Representative.
L-2 WARNINGS
Project 25 Warnings also fall into two
categories: Informational Warnings and
User Prompt Warnings. Informational
Warnings provide feedback to the user,
informing the user of results of actions.
User Prompt Warnings prompt the user
to perform some action to continue.
L-2.1 Project 25 Informational
Warnings
The following Project 25 Informational
Messages occur as the result of some
user or system action. All of these
To Next Page
Loading...