General Dynamics C4 Systems URC-200 (V2)
140
2) Place the transceiver in the supplied canvas carry bag, if desired.
3) Move to desired location and transmit and receive normally using battery power.
7.2.4 Backpack System Troubleshooting
When troubleshooting the Backpack System, ensure the following connections are
secure:
• UAD-100A Power Supply to URC-200 Transceiver
• UVU-100 Antenna to URC-200 Transceiver
• VAC Power Source to UAD-100A Power Supply (if using AC power)
• PTHS-110 Handset to URC-200 Transceiver
Also, check to make sure the transceiver is configured properly. Refer to paragraph 4.4
of this document, for specific instructions on configuring the radio. For specific tests and
troubleshooting, refer to Section 5.0 of this document.
7.2.5 Backpack System Remove and Replace Procedures
To remove any of the system components, follow these guidelines:
• Ensure the transceiver is powered down, and that the power supply is not
connected to an AC power source.
• To remove the antenna, handset, or uninterruptable power supply, simply unscrew
the antenna, disconnect the handset, or unlatch the power supply.
• To remove the transceiver, disconnect the antenna, handset, and power supply.
• To remove or replace the batteries in the uninterruptable power supply, unlatch
the power supply from the transceiver, and remove the batteries.
To Next Page
Loading...
Need help?
General