General Dynamics URC-200 (V2) User Manual

General Dynamics C4 Systems URC-200 (V2)
50
Table 11 - Remote Transceiver Operation Commands
CODE NAME DESCRIPTION
EQUIVALENT
TRANSCEIVER
KEYPAD
COMMAND
Z
Zap
Command sent to the transceiver to
disregard the current remote command (or
partial command) and re-sync. Transceiver
will ACK/HT
None
$
Squelch Control
The "$" Command followed by three digits
in the following format adjusts the remote
squelch.
“$xxx”
where:
‘xxx’ = a decimal number from 000–255.
When in remote mode, the transceiver uses
the remote squelch value rather than the
squelch knob setting. The remote value is
initialized to the knob value when a remote
session is initiated.
(There is no equivalent
keypad response for
the $ Command. The $
Command is
equivalent to the
SQUELCH Control on
the Transceiver’s front
panel, see Paragraph
4.4.1)
I
Channel
Initialization
Initializes all channels to the default values
(AM, PT, low power, 225 MHz, Wideband
(25 kHz), Aviation Mode Off).
Press
6
MODE
and turn ON
transceiver
(See Paragraph 4.4.2)
L
Lamp Control
The “L” Command followed by a 0, 1, 2,
or 3 selects the intensity of the
transceiver’s display backlighting
"L0" = Lamp Off
"L1" = Lamp Low
"L2" = Lamp Med
"L3" = Lamp Hi
9
LAMP
(See Paragraph 4.4.3)
J
Speaker On/Off
The “J” Command followed by a 0 or 1
selects whether the transceiver’s internal
speaker is OFF or ON.
"J0" = Speaker Off
"J1" = Speaker On
3
SPKR
(See Paragraph 4.4.4)
K
Calibration
The "K" Command performs the self-
calibration of the transceiver’s preselector
tuned filters.
None

General Dynamics URC-200 (V2) Specifications

General

Brand	General Dynamics
Model	URC-200 (V2)
Category	Transceiver
Language	English