Genmega G1900 - Customer Transactions; Opening Procedure

Section 6: Customer Transactions Operator Manual
G1900™
© Genmega 2011
6.1
CUSTOMER TRANSACTIONS
6.1 OPENING PROCEDURES
This section explains how to place your ATM in service.
Step 1
Open the front panel and turn the power on. (see page 4.1)
Step 2
If there is no receipt paper, load the receipt paper. (see page 4.12)
Step 3
Open the security door and replenish the cash cassette. (see page 4.9)
Step 4
Go into the OPERATOR FUNCTION mode and input the number of bills in the cash
cassette. (See page 4.14)
Step 5
Exit the OPERATOR FUNCTION MODE.
Step 6
After connecting to the processor, the terminal will be ready for service.
Step 7
If the machine is not ready for service, please check the following:
1. Determine if the phone line is properly connected;
2. Determine if all communication parameters are correct;
3. If, after doing the above steps, the ATM is still not in service, contact your
service personnel.