Appendix A: Error Codes Operator Manual
G1900™
© Genmega 2011
A.6
ERROR
CODES
ERROR DESCRIPTION CORRECTIVE ACTION
F000A Master Key is empty. Check Master Key checksum – reinject key (Host Setup)
F000B Host Telephone Number is
not set.
Set Host Telephone Number – (Host Setup)
F000C Error Retry timer is not
set.
Set Error retry time (Host Setup)
F000D RMS Password is not set
when RMS is enabled.
Set RMS Password – (Host Setup)
F000E RMS phone number is not
set when RMS send is
enabled.
Set RMS Phone number – (Host Setup)
F000F Terminal ID is not set. Set Terminal ID number – (Host Setup)
F0010 Routing ID is not set. Set Routing ID number – (Host Setup)
F0011 Master Key Serial number
is not set
Set Master Key serial number – (Host Setup)
F0013/
14
NVRAM Failure Fatal error, defective memory chip. Replace Mainboard.
F0015 Serial Number not Set Set Serial number in Operator Menu
F0016 Master Password left at
default
ATM will not go into service with the default master
password. The master password must be changed from
default.
To Next Page
Loading...