22 GS15
plus
Pen Holder and Pens
The pen holder is shipped with a black pen installed. After loading the
plotting paper, install the pen holder in the carriage spindle as follows:
To install the pen holder
1. Select the pen holder with pen installed from the tool rack molded in
the rear cover.
2. A plastic lift washer is used to reduce friction between the tool
holder and the lift fork of the carriage spindle during operation.
There should be one installed on the pen holder. If not, slip a lift
washer from the tool kit over the barrel and slide the washer to the
top of the holder.
3. Drop the pen holder into the carriage spindle. A slot, or keyway, in
the barrel of the pen holder ensures proper orientation. If necessary,
rotate the pen holder until it drops completely into the carriage
spindle.
4. When the pen holder is in place, swing the tool force arm and snap it
over the cone-shaped cap.
5. For plotting, start with a tool force setting of about .5. If the pen
does not make a clear, dark line, increase the tool force setting.
To Next Page
Loading...
