Gerber GS15 Plus - Reset

40 GS15
plus
RESET
Use the RESET key to stop plotter operation in case of emergency, to
clear error signals, and to access Special Diagnostics.
To cause an emergency stop
Press the RESET key while a job is plotting. The following sequence
occurs:
1. GS15
plus
operation stops immediately.
2. The current job is cleared. All other jobs in the queue remain intact.
3. The GS15
plus
returns to off-line status, as at power-up.
To clear an error signal
Press the RESET key to clear an error (steady tone and flashing lights)
after a power-up or plotting failure. (See the "Error Conditions"
section.)
To access diagnostics
Hold the RESET key at power-up to access additional diagnostics. (See
the "Special Diagnostics" section.)
RESET