47
ERROR CONDITIONS
The GS15
plus
is programmed to detect several mechanical/electrical
error conditions at power-up or during operation. When an error
condition occurs, the plotter will turn off power to the stepper motors,
flash the RUN lights, and sound a steady tone.
To determine the error condition that stopped plotter operation, follow
these steps.
1. Press the RESET key to clear the error signal (flashing lights and
steady tone).
2. Press the RUN SINGLE key to display the error code number. The
RUN lights flash the same number of times as the error
number (once for Error 1, twice for Error 2, etc.). A short beep
indicates the end of the error message. Press the RUN SINGLE key
again to repeat the message, if desired.
3. Press the RESET key to clear the error display mode and return to
the initial off-line status.
To Next Page
Loading...
