66 GS15
plus
X Axis Belt Adjustment
SYMPTOMS
Text cut in AXIS SWAP mode has closure problems.
OBJECTIVE
To adjust the tension of the X motor belt to produce good letter quality
in AXIS SWAP mode.
ADJUSTMENT PROCEDURE
1. Turn the plotter power off.
2. Remove all tools and material from the plotter.
3. Open the bail arms.
4. To remove the front cover, lay the GS15
plus
on its left side and
remove the (2) Phillips head screws on the bottom edge closest to
the front of the plotter. Then stand the plotter upright.
CAUTION: Do not rest the plotter on its right side. Do not use
the way shaft to lift or turn the plotter.
To Next Page
Loading...
