33
OPERATION
Power-Up
When the GS15
plus
is turned on, the following sequence occurs:
1. A short beep sounds, the Power light comes on, and the RUN
CONT, RUN SING, and SWIVEL KNIFE lights blink.
2. As the GS15
plus
performs self-check tests, the lights over the RUN
and SWIVEL KNIFE keys flash, and one additional beep sounds.
3. When the self-check is complete, the lights blink and one beep
sounds.
4. The plotter goes off-line in tangential knife mode. Only the Power
light remains on. This is the initial setting at power-up.
Note: Rapid, continuous beeping and flashing lights may signal a self-
check error. See the "Error Conditions" section for more information.
To Next Page
Loading...
