Gerber GS15 Plus - Page 94

continuous exercise ..................39
single exercise ..........................38
Square/Circle test plot42, 44, 45, 60
Wagon Wheel test plot.......43, 60
Plotter ...........................................56
adding plotter............................12
assign default plotter ................13
delete plotter.............................12
installation..................................7
speed...................................25, 26
Plotter adjustment.57, 61, 66, 69, 73
Pounce wheel................................25
holes, aligned............................25
holes, off-center........................25
replacement...............................26
Pounce wheel holder ....................25
Pounce Wheel Holder
installation................................25
Power cord................................9, 53
Power-up.......................................10
RESET key held at ...................40
RESET key...................................40
Roll holder, material.....................15
RS-232 loop-back.........................42
RUN CONT key...........................38
RUN SINGLE key........................37
Slew keys................................35, 39
SLOW key....................................35
Sprockets ................................16, 52
Square/Circle test plot......42, 44, 60
Stop, controlled ......................37, 39
Stop, emergency ...........................40
Swivel knife..................1, 28, 31, 36
Tangential knife..................1, 28, 36
Theta axis
adjustment ................................61
Tone..............................................33
Tool force
adjustment ..........................19, 20
dial............................................19
housing .....................................62
pouncing...................................26
settings......................................29
Tool height adjustment.................57
Tool rack, molded ..................21, 25
Tool rotation adjustment..............61
Troubleshooting ...........................56
Vinyl.............................................15
Wagon Wheel test plot...........43, 60
X axis
backlash adjustment.................69
X, Y, theta axes
lock time-out ............................48
X, Y, Z axes
lock time-out ............................48
Y axis
backlash adjustment.................69
Z axis
tool height adjustment..............56
tool height adjustment..............57