GIRBAU PB32 Series User Manual

Operating and use. Inteli Control 105
Code no. 550038
Rev. no. 16/1018
7.7.2. Information menu. Introduction and access
The information menu allows access to information concerning the configuration and to the life of the ironer:
 General information. About the ironer model and the control characteristics.
 Operation counters. These register the hours of operation and the linear distance covered by the rolls.
 Alarm counters. There is a counter associated with each one of the main system alarms that is increased
with the appearance of each alarm.
To move among counters and within each counter use the multi-function keyboard.
There is an option on the SETUP menu that allows setting the value of the different counters at zero. This
operation is reserved for the Authorised Technical Services.
Below, the distinct parameters that make up the INFO menu are listed.
General information. Contents
 Machine model. Identifies the ironer model
 Program version
 A2 board version
 A4 board version
 Free programs
 Updated information
Only machines with gas heating.
 Oil probe calibration. Calibration value of the oil temperature control probe.
 Fumes probe calibration. Calibration value of the fumes exhaust temperature control probe.
Operation counters
 Operating time
 Linear Km/miles of operation
Alarm counters
List of controlled alarms
A2 BOARD COMMUNIC. ALM
HEATING CONFIGURATION ALM
HAND GUARD ACTIVATION
ROLL OVERHEATING ALM
A2 BOARD RESET
TEMPERATURE PROBE 1 ALM
INVERTER COMMUNICATION ALM
TEMPERATURE PROBE 2 ALM
GENERAL INVERTER ALM
TEMPERATURE PROBE 3 ALM
INVERTER CONFIGURATION ALM
TEMPERATURE FAILURE ALM
NOT RESETTABLE BURNER ALM
ENCODER ALM
SAFETY THERMOSTAT ALM
EXHAUST PRESSURE ALM
GENERAL BURNER ALM
EXHAUST OVERTEMP. MOTOR ALM
HEATING CONTROL ALM
FOLDER CONTROL ALM

GIRBAU PB32 Series Specifications

General

Brand	GIRBAU
Model	PB32 Series
Category	Iron
Language	English