Operating and use. Logi Control 120
Code no. 550038
Rev. no. 16/1018
8.5.7. Code for accessing the ADVANCED MODE. Ncod menu
As described in Section 8.5.1 the access to ADVANCED MODE is restricted by an access code.
This code can be modified by the user if so desired.
The code must always contain a combination of EIGHT numbers.
Modifying of the access code
Access to ADVANCED USE MODE. Section 8.5.1. The display shows Pro.
Press the key three times. The display shows INFO, Mod, NCod successively.
Press the key to set a new code. All the information on the display will disappear.
Enter a combination of eight-digits according to the following numerical equivalence:
At the end of the sequence the SURE report will be shown.
Confirm the new code with the key .
If you don’t want to validate the code, press the key.
In both cases, the display will show Ncod.
The keys allow the user to access to other menus.
To exit the ADVANCED MODE press the key.
NOTE
If you forget the modified code, call the Service Department to restore the original code.
To Next Page
Loading...
Need help?
General
