Interruption of the power supply 122
Code no. 550038
Rev. no. 16/1018
10. UNEXPECTED INTERRUPTION OF THE POWER SUPPLY AND PROLONGED HALT
In the case of a sudden loss of the power supply the machine stops.
Once the power supply has been reconnected, the CHECK report is displayed. (To resume work, follow the
directions set out in the respective OPERATION AND USE chapters.)
10.1. Protection against burnt linen and ironing
straps
In the event of an unexpected shutdown of the machine, and
in order to prevent deterioration of the linen at that time in
contact with the roll or ironing straps, the ironer is equipped
with a crank handle that allows the roll to be rotated manually.
Once the items of linen in contact with the roll have been
extracted, if the roll temperature is very high, a wet sheet
should be passed through the whole roll by operating the
handle, in order to protect the ironing straps.
The handle is located at the rear of the ironer (Fig. 10.1).
PB32, X13 models
1. Turn off the automatic external switch.
2. Insert the helical end of the crank handle through the
opening in the top left-hand side cover of the machine and
insert it into the end of the internal shaft (Fig. 10.2).
3. Turn the handle in the direction of the arrow. The roll will
rotate in the ironing direction, and the ironing straps and
the linen input straps will move towards the inside of the
ironer.
4. VERY IMPORTANT!!! Before resuming operation of the
machine, remove the handle and store it in its support
at the rear of the machine (Fig. 10.1).
To Next Page
Loading...
Need help?
General
