Operating and use. Inteli Control 88
Code no. 550038
Rev. no. 16/1018
7.5.5. Indicating preferable “OPTIFEED” ironing area
The ironer’s control detects the differences in temperature between the areas of the cylinder, and indicates, by
illuminating the linen feeding table, which is the area or areas (Area 1, 2 or 3), on which it is preferable to iron
(Figure 7.2).
Following all the combinations of these three ironing areas prevents the cylinder from overheating, increases
performance and optimises the machine’s consumption.
For further information on the OPTIFEED system, see the following video:
https://www.youtube.com/watch?v=oyhcq0YZutI
Fig. 7.2
CAUTION!
Using the ironer WITHOUT using the "OPTIFEED" system generates a lower yield and at the same time may
shorten the life of some of the machine’s parts.
CAUTION!
For mode OPTIFEED to be active, the program execution screen needs to be displayed (Section 7.5.1).
The intensity of the feeding table light is configurable (Section 7.7.1).
To Next Page
Loading...
Need help?
General
