Maintenance 137
Code no. 550038
Rev. no. 16/1018
13.1. Checking safety mechanisms
CAUTION! Operation to be performed by the user or by the customer’s technical service
13.1.1. Checking the HAND PROTECTION device
DAILY check the HAND PROTECTION device.
Checking procedure:
Switch off the power supply input switch
breaker.
Wait for at least five seconds and then turn
the isolator switch on again.
The ironer icon is displayed with the CHECK
message, and the buzzer sounds.
Press the hand protection device.
The ironer icon disappears, the buzzer stops,
and the MAIN MENU icons are displayed on
the screen.
CAUTION
If anything other than that was described is detected during the operation, disconnect the machine, do not use it,
and contact the Authorised Technical Service URGENTLY.
13.1.2. Checking the EMERGENCY STOP
CAUTION! Operation to be performed by the user or by the customer’s technical service
Check the Emergency Stop on a WEEKLY basis.
Checking procedure:
Connect the ironer and start an ironing program.
Press the emergency stop button.
The roll will stop rotating and the heating system will turn off.
The buzzer will sound and a warning message will be displayed stating that the Emergency Stop is activated.
Unlock the Emergency Stop button.
Press the STOP key on the multi-function keyboard. The Emergency Stop icon disappears, the buzzer stops,
and the MAIN MENU icons are displayed on the screen.
The REV key allows the roll to rotate in the opposite direction to the linen input direction. Use only under
exceptional conditions.
CAUTION
If anything other than that was described is detected during the operation, disconnect the machine, do not use
it, and contact the Authorised Technical Service URGENTLY.
To Next Page
Loading...
Need help?
General
