Location 28
Code no. 550038
Rev. no. 16/1018
3.1. General information and location
To ensure that the ironer functions properly and safely, the location and installation instructions set out
in the corresponding sections must be complied with, in particular:
Hazard warnings.
Installing the different protection elements indicated.
Indications relating to the location of the machine.
Indications relating to the areas of use indicated in the corresponding plans.
Size and connection of the ducts for the heating supply: gas, steam.
Size and connection of the electricity supply conduits.
Size and connection of the exhaust duct.
Technical features on the ironer and complementary information on the installation chapter 4 and 5.
CAUTION!
THE OPERATIONS INVOLVED IN LOCATING THE MACHINE MUST BE CARRIED OUT BY AUTHORISED
TECHNICAL SERVICES.
The machine must be installed on a flat floor surface, perfectly even and capable of supporting the weight of the
machine. A concrete floor with a resistance equal to or greater than 250kg/cm
2
(4,000 psi) is recommended.
The location surface must be free of any inflammable covering.
Take into account the minimum amount of space required for use. This space facilitates good working
conditions and machine maintenance. Refer to operating zones and values in Fig. 3.1.
If the ironers are installed on metal surfaces the aforementioned surfaces must be grounded by an electric wire
independent to the ground ironer connection.
To Next Page
Loading...
Need help?
General
