Operating and use. Inteli Control 93
Code no. 550038
Rev. no. 16/1018
7.6. Programming mode
The ironer control is capable of storing up to a maximum of 50 programs.
Program number 1 is pre-set at source and cannot be changed.
The remaining programs are empty of content.
7.6.1. Access to programming mode
On the main menu screen, select the
PROGRAMMING MODE icon.
Press the OK key. The following screen
appears.
PROGRAMMING MODE options:
A. Programming a new program (Section
7.6.2.).
Specific information of folding modes
(Section 7.6.3).
B. Modification tools (Section 7.6.4.).
To Next Page
Loading...
Need help?
General
