Location 27
Code no. 550038
Rev. no. 16/1018
3. POSITIONING
CAUTION!
THE MANUFACTURER IS OBLIGED TO ADVISE YOU THAT FAILURE TO INSTALL THIS MACHINE
PROPERLY MAY PRODUCE A FAULT OR CAUSE POOR MACHINE OPERATION RESULTING IN
SERIOUS BODILY INJURY. THE MANUFACTURER DECLINES ALL RESPONSIBILITY IN THESE CASES.
THE SPECIFICATIONS NAMEPLATE IS LOCATED ON THE LEFT-HAND SIDE OF THE REAR AREA
(FRONT VIEW OF THE MACHINE).
CAUTION!
THE IRONER MUST BE INSTALLED ON A FLAT FLOOR SURFACE, PERFECTLY EVEN AND CAPABLE
OF SUPPORTING THE WEIGHT OF THE MACHINE.
ANY INFLAMMABLE SUBSTANCES COVERING THE FLOOR SUCH AS RUGS AND CARPETS MUST BE
REMOVED.
A FIRE EXTINGUISHER MUST BE PLACED INSIDE THE PREMISES, IN A PLACE EASILY VISIBLE AND
EASILY ACCESSIBLE. TYPE OF FIRE EXTINGUISHER AND LOCATION: MUST BE IN ACCORDANCE
WITH THE REGULATIONS OF THE COUNTRY IN WHICH THE IRONER IS INSTALLED.
CAUTION!
BEFORE STARTING UP THE MACHINE, REMOVE ALL THE SECURING DEVICES FOR TRANSPORT.
ADVISABLE TO KEEP THE FIXINGS IN CASE THEY ARE NEED FOR SUBSEQUENT USE.
CAUTION!
SPECIFIC WARNING FOR IRONERS WITH GAS HEATING.
BEFORE CARRYING OUT THE INSTALLATION OF THE MACHINE, CHECK THE LOCAL GAS SUPPLIES
(TYPE OF GAS AND PRESSURE) ARE COMPATIBLE WITH THE EQUIPMENT REQUIREMENTS.
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE RULES IN FORCE, AND MUST BE
USED ONLY IN AREAS THAT ARE ADEQUATELY VENTILATED.
CAUTION!
SPECIFIC WARNING FOR MACHINES INSTALLED ON USA/CANADA PREMISES.
TO REDUCE THE RISK OF FIRE, THIS MACHINE MUST BE INSTALLED ON A CONCRETE FLOOR
WITHOUT ANY COVERING.
To Next Page
Loading...
Need help?
General
