General description 13
Code no. 550038
Rev. no. 16/1018
Fume and vapour extraction
Centrifugal extraction of the vapours from the linen ironing, and of the fumes from the combustion (gas version).
Exhaust circuit lint filter.
Extractor operation safety control.
In models with gas heating, the fume extraction system has a flow rate control system that allows the
combustion to be adjusted.
Controls
Overall ironer operation controlled by a microprocessor.
Serial communication with the inverter.
Analogue temperature control.
Specific software that allows control and management of the ironing processes. The roll’s temperature and
speed parameters during the ironing process can be selected automatically or manually at the discretion of the
user.
Control panel. Operator/system interface consisting of keyboard and display.
Alarm messages to aid in diagnosing possible malfunctions.
LOGI CONTROL. Models PB32 and X13
Interface: alphanumeric display and keyboard.
10 pre-recorded and modifiable ironing programs.
Manual and automatic roll speed control.
Changing of the ironing parameters while a program is running.
TEST program for diagnosing problems.
INTELI CONTROL. Models PB/PBP51 and X20
Interface: graphic screen and keyboard.
Storage capacity for 50 ironing programs.
Manual and automatic roll speed control.
Changing of the ironing parameters while a program is running.
TEST program for diagnosing problems.
PBP51 and X20***F models. Models with a linen folder.
Description of the folder.
Longitudinal linen folding system located at the lower front and based on a swinging arm driven by an electric
linear actuator.
Straps and linen extraction tray powered by an electric motor and clutch.
Photocells that detect the linen passing. There is one ore more photocells fitted to the feeding tray and another
before the linen reception area.
As an option, the machine can be equipped with three pairs of photocells to aid in ironing narrow articles using
the entire surface of the ironer.
Software to measure the length of the folded pieces and determine the number and width of the folds. These
calculations can be made manually or automatically, as the operator wishes.
Specific information relating to protection, safety and control elements. See Section 1.6 of this
chapter.
To Next Page
Loading...
Need help?
General
