180
Figure 6-114 Viewing RAID information
Figure 6- 114
To configure a hot spare disk:
After configuring RAID, a hot spare disk is generally configured to improve data security. Global hot
spare disks and dedicated hot spare disks can be configured as required.
Hot spares are only used for RAID levels where redundancy exists.
The capacity of the hot spare disk is larger than the capacity of a single RAID member disk to contribute
to the RAID.
Only disks whose configuration mode is Unconfigured Good are supported as hot spare disks.
Configuring a global hot spare
As shown in Figure 6-115, select the disk to be configured as a global hot spare on the PD Mgmt
interface, and press F2.
Figure 6-115 Selecting the disk to be configured as a global hot spare
To Next Page
Loading...
Need help?
General
