Preparation
3A6748B 17
Extension Cords
Use an extension cord with an undamaged
ground contact. If an extension cord is
necessary, use a 3-wire, 12 AWG (2.5 mm
2
)
minimum.
NOTE: Lighter gauge or longer extension
cords may reduce sprayer performance.
Mixing Material
NOTE: Correct material mixture is essential.
The pump and spray gun will not operate if
the mixture is too thick. Use water-based
materials only.
1. Mix the material and water in a
separate container.
Dry Mix
Carefully mix texture material and water
according to manufacturer instructions
on bag.
Premix
Slowly add water to a 5 gallon (18.9 liter)
bucket of premix.
2. Agitate to mix with mixing paddle, to a
smooth, lump-free consistency.
3. Make certain all dry powder clumps are
mixed throughly before pouring mixture
into the sprayer hopper.
ti2496c
40 lb.
TEXTURE MIX
5 GAL
NOTICE
Failure to make certain that all dry powder
is throughly mixed may cause tip or pump
clogging.
ti30766a
To Next Page
Loading...
