Start Up - Airless
3A6748B 25
e. Once a steady stream flows from
the material hose, run for an
additional 30 seconds.
f. Turn ON/OFF Switch to OFF.
4. Install filter or air passage plug and tip
extension. Material consistency and tip
size will determine which filter size to
use. In certain instances, air passage
plug with no screen is needed with large
tips to successfully spray materials with
sand or rock.
5. Connect applicator to material hose.
6. Turn ON/OFF Switch to ON.
7. Turn applicator ON. Turn Pressure
Control Knob clockwise until desired
material delivery rate is achieved. Run
for 15 seconds.
To Next Page
Loading...
