iv
Safety Precautions (Continued)
CAUTION
Do not use or store the cutting plotter in a location exposed
to direct sunlight or the direct draft of an air conditioner or
heater.
• Such locations may impair the performance of the cutting plotter.
Do not use the cutting plotter in an excessively dusty or
humid location.
• Such locations may impair the performance of the cutting plotter.
Do not place any receptacle containing water or other fluid on
top of the cutting plotter.
• Fluid falling inside the cutting plotter may cause electric shock or
a fire hazard due to current leakage.
Do not use the cutting plotter in a location subject to
excessive mechanical vibration or electrical noise.
• Use in such locations may impair the performance of the cutting
plotter.
When disconnecting the power cord or interface cable, do not
pull on the cord/cable.
• Such action will damage the cord/cable, resulting in a fire hazard
or electric shock.
If water or foreign matter enters the cutting plotter,
discontinue use. Turn off the power and unplug the power
cord from the electrical socket.
• Use of the cutting plotter in such a condition may result in
electric shock or a fire hazard due to current leakage.
• Contact your sales representative or nearest Graphtec vendor
for repairs.
Prohibited
Prohibited
Avoid water
Beware of electric shock
Prohibited
Prohibited
Unplug the power
cord from the socket
To Next Page
Loading...
